Induction · signal
Two Zones On, Both Slower: Power Sharing
Boost on a Wolf induction cooktop gives one zone extra power by borrowing it from the zone beside it, so a neighbour set to high slows while boost runs.
| If you see | And | Then | Verdict |
|---|---|---|---|
| Boost on, and the zone next to it slows | Its power level indicator has dropped below what you set | That is boost borrowing power. When boost ends, the neighbour gets its share back. | Safe to wait |
| Boost switches itself off | It had run without a break for about a quarter of an hour | Wolf's current guide ends boost after roughly 15 minutes of continuous use. Touch Boost again if you still need it. | Safe to wait |
| Boost will not start on one zone | Wolf's element table lists that zone without boost | Not every zone is built for it. Move the pot to a zone that boosts. | Safe to wait |
| One zone slow, no boost set anywhere | The same magnetic pan heats quickly on the other zones | That zone is falling short on its own. Note which zone it is and the model number. | Call today |
| Every zone slower than it used to be | No boost is running and the pans are magnetic | Wolf's guides point to low supply voltage or a loose connection. Have an electrician check the supply first. | Call today |
If every zone stays slow with no boost set and an electrician finds the supply sound, call Redmond Wolf Repair on (425) 905-2822 and say which zones lag.
Where the extra power comes from
Boost moves power rather than adding it: Wolf’s current guide has it diverting power from the adjacent element, and when that element is on high its output drops, with the lower level shown on its own indicator. The older CT tops call the feature Hi-Power and pitch it at frying and fast boiling.
Which zones boost
In the rating table on the features page of the current guide, the largest zone on every width boosts, the 6-inch zones on the 15- and 30-inch tops do not, and the 8-inch zones are split, some with boost and some without.
When the supply is the question
Wolf’s installation guide calls for a circuit that serves the cooktop alone and lists the induction tops for a 240 or 208 volt supply; the use and care guide adds that performance may suffer below 240 volts. Checking that is an electrician’s job. If the supply is sound and the zones are still slow, the cooktop itself needs a look.