Wolf · Redmond
Cooktop Repair
Wolf gas, electric radiant and induction cooktops — igniters, spark modules, element boards, touch controls and downdraft integration.
What people describe when they call
- An induction zone cuts out mid-cook and flashes a code, then works again once it cools
- A radiant element stays on full heat no matter where the knob is set
- There is a gas smell around the cooktop even when nothing is lit
- The touch panel only responds every third or fourth press, usually near the front edge
What the visit covers
- Induction generator and cooling fan faults
- Radiant element and relay board testing
- Spark module and burner cap alignment
Every visit starts with measurement rather than replacement: gas pressure and flame quality where it applies, element and sensor resistance where it does not, and board voltages before any board is condemned. You get the part price and the labour before a single screw comes out.
What it costs
Repair prices, before anyone opens the appliance
Where a job lands inside its band comes down to the part your serial number takes and how far the appliance has to come apart to reach it. You are given the figure for your kitchen first, and it is the figure you pay.
The visit
Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.
The repair itself is quoted from the bands below and agreed with you before any work starts — the part, the labour and the total, in one number. Nothing is dismantled, ordered or replaced until you have said yes, and the number does not move after you have.
- Igniter or spark module$190 to $430
- Burner valve or orifice service$260 to $570
- Oven thermostat or sensor calibration$190 to $440
- Convection fan or motor$300 to $670
- Control board or touch panel$480 to $920
- Door hinge, glass or seal$300 to $670
For comparisonA comparable professional range, before installation and ventilation work runs $8,630–$18,590 to replace. Measured against that, every band above is the smaller decision on a machine that is otherwise sound — and on the day it stops being the smaller decision, you will hear that from the technician standing in front of it rather than afterwards.
In their words
What Redmond kitchens say afterwards
There was a faint gas smell around the cooktop with nothing lit. He soap tested every joint and found one weeping fitting under the burner box. Sorted that afternoon, and I am glad I rang instead of waiting.
Zora A.Downtown Redmond
One radiant element stayed at full heat wherever the knob sat, which felt unsafe with children about. The relay had welded shut. New element board, and the low settings behave properly again.
Hedy W.Education Hill
An induction zone kept cutting out mid-cook and flashing a code. Not the generator board we were braced for: the cooling fan underneath was choked with dust. Cleared, and it has run clean since.
Greg & Lynn T.Redmond Ridge
Book a visit
Book a wolf cooktop visit
Booking runs on our scheduling page, so you can see what is actually free and take it. A model number and a sentence about the fault is usually enough for us to load the right part before setting off — the difference between one visit and two.
- Phone (425) 905-2822
- Hours 8:00 am – 8:00 pm, seven days · line answered 24/7
- Service call $89, credited against an approved repair
- Coverage Downtown Redmond · Overlake · Education Hill · Redmond Ridge
If you can smell gas, do not book online — call (425) 905-2822 and we will treat it as urgent. The line is answered 24/7.
- Pick your slot Day and arrival window, chosen by you on the booking page. Tell it which Wolf appliance is playing up and roughly what the cooktop is doing — that is usually enough for us to load the likely parts before setting off.
- We confirm by text You get a real two-hour window and the name of the technician who will be at the door — never an all-day wait and a shrug.
- Measured, then priced The visit is a $89 service call. Gas pressure, element and sensor resistance, board voltages — measured, not guessed. You get the part and labour price before anything is opened up, and the service call comes off the total in full if you approve the repair.
Rather talk it through, or can you smell gas? Call (425) 905-2822 — answered 24/7.
- Visits run 8:00 am – 8:00 pm, seven days
- The line is answered 24/7
- Downtown Redmond · Overlake · Education Hill · Redmond Ridge
Next step
Tell us what it is doing
Take a two-hour window on the booking page — about a minute — or call and we will find one for you. We run Redmond and the plateau 8:00 am – 8:00 pm, seven days, and the line is answered 24/7.